Amac Engineering

Re-Bore

Home Page

 

 

 
 
Block re-bored and honed.
When the cylinders of an engine become worn it is necessary to re-bore them. Here at Amac engineering we normally do this by either re-boring the block, therefore increasing the capacity of the engine and fitting oversized pistons, or re-boring the block oversize and fitting inserts called liners, as shown below. Re-boring an engine is normally only necessary when the engine has done high miles, unless there has been some kind of mechanical failure. The life of a bore is prolonged with regular servicing, i.e. engine oil changes.
 
 
 
Reboring of a bike block with liners installed.
Block re-bored and ready for honing.
 
     
Contact Details
Back